The username is cucumber and the password is stinky. If you do not know the location of the AP check the DHCP leases in your router. When the AP is fully booted and has an ip-address, navigate to its ip. Setting the MAC Address of the APīy default, the MAC address of Meraki access points are not recognized by WRT-based operating systems. Also, connect your computer back to the internet. After the AP reboots, connect the ethernet cable on the AP to an internet source. It will take approximately 5 minutes to flash, and if the device is still flashing after ~10 minutes, reboot and try again. While still holding the reset button, you should see the file being transferred in pumpkin, and after the file is transferred keep holding down the reset button until all the lights on the front of the AP start flashing, then you can let go. Grab a paperclip and press and hold the reset button. Flashing the Cucumber ImageĬonnect an ethernet cable between your computer on the wired interface you set a static ip and the Meraki AP. Go back to the “Server” tab and for the “TFTP Filesystem Root” specify the location of the vmlinux.gz.uImage file. When it is launched, select the “Network” tab and input 192.168.1.101 in the ip-address field. From here, launch the pumpkin TFTP server.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |